Filter
Top Products
Installation
13
Mio Modero Device Family
Podium Mounting
1.
Use the cutout dimension shown in either FIG. 8 or FIG. 9 to cutout the mounting frame install
surface for the Mio Modero.
2. Confirm that the terminal end of the AxLink cable is disconnected, and not receiving power.
3. If the faceplate is connected to the mounting frame, place a flathead screwdriver in the notch at the
bottom right of the Mio Modero, and pry the faceplate from the mounting frame.
4. Connect the AxLink power supply. The connector passes through the center of the mounting frame
and connects to the board. The connection is illustrated in FIG. 2.
5. With the mounting frame resting in the cutout area, drill the mounting holes into the flat surface.
6. Attach the faceplate to the mounting frame first at the top and swing it to the bottom. See FIG. 10
FIG. 10 Attaching the faceplate to the mounting frame
Do not overtighten the screws when mounting the mounting frame. The device
should be flush with mounting surface.