Filter
Top Products
35
10.2 Using MPG4 Translator
Here you see the image of the main MPG4
Translator program. When you fi rst run
the program, if the DivX™ codec has not
been installed yet, you will be notifi ed. You
should download the codec and install it on
your computer. If the Virtual dub program
has not been installed, you will also be
notifi ed, and you should install it (either
with the Archos Installation Utility or the
Virtual Dub website). If you have placed
the Virtual Dub program in a folder other
than the default, it will ask you to locate
the fi le.
Select Source & Destination Files
In the example above, a source fi le 24 hours of Lemans.avi has been selected
as the source video. You can see on the bottom of the window its original
characteristics (width 720, height 576, frame rate 25). Next, you must then tell
the program where to place (Set Destination fi le) the newly recorded version
of the fi le (don’t worry, it will not erase the original). You should give it a new
descriptive name, such as shown above Lemans_Gmini400.avi. Make sure you
add the .avi extension.
Change Settings
Next, you can change the parameters (Change Settings) of the DivX™
encoder to adjust the level of quality of the fi nal image. Like MP3 music,
the higher the bit rate setting is
made, the higher the quality of the
music, or video in this case, that
you will get. However, this will also
take up more space on your hard
disk. A setting of 900 kbps will give you a nice looking image for viewing
on a television. For near DVD quality, you can set it up to 1200 kbps. If
you do not use the standard version, uncheck the bidirectional encoding
in your DivX codec property page.