Audiovox DT102 DVD Player User Manual


 
System Panel Controls
DTT7810 Operation
11
SETTING THE CLOCK:
NOTE: All settings are preformed in standby mode.
1. Selecting 12 or 24 hour display mode:
a.) Press the “clock mode” button once. The 12H/24H and AM/PM indicator will flash.
b.) Press the “radio tune/clock set” (-) or (+) button to toggle between 12 or 24 hour modes.
2. Setting the time:
a.) Press the “clock mode” button twice. The hours and minutes will flash.
b.) Press the “radio tune/clock set”(-) button to set the hour. This will also set AM/PM.
c.) Press the “radio tune/clock set”(+) button to set the minutes.
3. Selecting the alarm type:
a.) Press the “clock mode” button three times. The alarm indicator will flash.
b.) Press the “radio tune/clock set” (-) or (+) button to toggle between the three alarm options
(Alarm/Radio and OFF). A musical note will appear to indicate the radio has been selected.
A bell will appear to indicate the alarm tone has been selected. If the alarm OFF mode is
selected there will be no indicator displayed
4. Setting the alarm time:
a.) Press the “clock mode” button four times. The alarm indicator will be displayed and the hours
and minutes will flash.
b.) Press the “radio tune/clock set” (-) button to set the hour. This will also set AM/PM.
c.) Press the “radio tune/clock set” (+) button to set the minutes.
Note: During any of the setting procedures if no buttons are pressed for four (4) seconds the
DTT7810FM will go back to standby mode.
OPERATION SELECTION:
Note: The DTT7810 default source is the DVD shuttle. When power is turned OFF the
DTT7810FM will default to the DVD shuttle.
SOURCE SELECTION:
1. DVD mode – When power is turned ON the DTT7810FM will be in DVD mode. When one of the
DVD shuttles is installed it will power ON a moment after the DTT7810FM is turned
ON.
2. TV mode – Press the “Source” button once.
The DTT7810FM will be in TV tuner mode.
3. AV mode – Press the “Source” button twice.
The DTT7810FM will be in AV mode. Any A/V source connected to the AV inputs on
the rear of the unit will be displayed.
4. Radio mode – Press the “Source” button three times.
The DTT7810FM will be in Radio mode. The unit will be in the last band that was
selected (FM1, FM2, or AM)