Filter
Top Products
-
8
) Choose an appropriat cation underneath a cabinet o ity to an electrical
outlet and a TV ante nection will facilitate a ne nt the
VE705 above a re that the location chose l ss to the
electrical connection on the rear of the unit before continuing.
) If the loca on chosen has a bottom edge molding it may be necessary to use the mounting spacers
provided to effectively lower the VE705 below or even with the molding. Measure the distance between
the edge molding and the bottom of the cabinet. The spacers and mounting holes are stepped to
achieve different mounting heights from .5” to 1”. Adjusting the mounting height is done by lifting and
rotating the spacer in the mounting hole. Choose a spacer height, which will allow the VE705 to clear
the edg
) Measur sen. Select the
shortest screw length, which will secure the VE705 to the bottom of the cabinet.
ch
the
ure
sources.
1 e mounting lo r shelf. Close proxim
nna or cable con at, easy installation. Do not mou
range or oven. Be su n wil provide adequate acce
2 ti
UNDER CABINET INSTALLATION
Edge Molding
e molding.
e the thickness of the bottom of the cabinet or shelf and the spacer height cho3
4) Cut out the template supplied and tape it in place onto the cabinet surface to be drilled. Center pun
the four holes indicated on the template and remove the template.
5) Carefully drill four 1/8″ holes at the locations marked above. Place the screws selected through
VE705 and then through the spacers (if required from the bottom-up)
6) Connect your TV antenna or cable system to the antenna connector on the rear of the VE705.
7) Attach the FM Dipole Antenna and position the antenna for the best reception.
8) Attach the AM Antenna and position the antenna for the best reception.
9) Position the VE705 and mount it in place using the selected screws.
(Note: Do not over-tighten.)
10) Plug the AC power cable into the wall outlet. Route the wires safely away from heat and moist