Filter
Top Products
61
Using external equipment
Setting the recording mode (i.LINK)
• The function for automatically adjusting the recording
mode of connected D-VHS decks can be turned on
or off.
• Since most of the currently available D-VHS decks
automatically recognize the transfer rates of the
pictures and sound being recorded and control the
recording mode accordingly, you should always set
this Mode to “Pass thru” in normal circumstances.
• Depending on the D-VHS deck used and the type of
broadcast being recorded, this System may not
adjust the recording mode properly. In this case,
please set the “Recording Mode” to “Pass thru”.
Press MENU and the MENU screen displays.
Press c/d to select “Digital Setup”.
Press a/b to select “i.LINK Setup”, and then
press ENTER.
1
2
3
Press a/b to select “Recording Mode”, and
then press ENTER.
4
Press c/d to select “Auto” or “Pass thru”,
and then press ENTER.
• Normally, this should be set to “Pass thru”.
5
Setting the Standby Mode (i.LINK)
• Power consumption during standby mode can be
minimized by changing the setting of the “Standby
Mode” in “i.LINK Setup”.
• When i.LINK is not in use, select “Inactive” in
“Standby Mode”.
Press MENU and the MENU screen displays.
Press c/d to select “Digital Setup”.
Press a/b to select “i.LINK Setup”, and then
press ENTER.
1
2
3
Press a/b to select “Standby Mode”, and
then press ENTER.
4
Press c/d to select “Active” or “Inactive”,
and then press ENTER.
5
“Active”: Power continues to pass through the i.LINK
circuit so data can be relayed.
“Inactive”: Power consumption is minimized during
stand-by mode. Data cannot be relayed at this
setting.
NOTE
• When the main power of the System is in standby mode
(POWER indicator lights off), i.LINK control commands
cannot be received from a D-VHS deck. This does not
change even if the “Standby Mode” is set to “Active”. To
control the System from a D-VHS deck, turn the System
power on (POWER indicator lights up in blue).
• Data cannot be relayed between i.LINK devices when all
the following conditions are met: 1) More than one i.LINK
device is connected to the System with i.LINK cables, 2)
“Standby Mode” is set to “Inactive”, and 3) The power of
the System is in standby mode (POWER indicator lights
off). When the System is connected between two i.LINK
devices in series, select “Active” in “Standby Mode” or
connect the System at an end of the series as shown in
the diagram.
LC-45GX6U(E)-060-065 04.7.8, 8:52 AM61