Filter
Top Products
Connections
6-1
5975348 BARCOVISION 8200 280497
6
CONNECTIONS
RS232 OUT
IR- ACKNO WLEDGED
I R-RECE IVE D
DI AG NOS TICS
CODE
I R-RECE IVE R
100 - 230 V
9 - 4 A
60 - 50 Hz
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall
outlet. Plug the female power connector into the male connector at
the front of the projector.
The power input is auto-ranging from 100 to 240 VAC.
This projector may be connected to an IT-power system.
Fuses
Warning
For continued protection against fire hazard :
- refer replacement to qualified service personnel
- ask to replace with the same type of fuse.
Fuse type : T12.5 AH/250V
CONTRASTCOLORPHASE
SHARPN TINT BRIGHTN
STANDBY
ENTER
TEXT
EXIT
PAUSE
2
1
4
3
5
6
8
0
9
7
Stand by button
ADJ EXIT
STBY TEXT
BRIGHTN ESS
-
+
-
+
-
+
-
+
SHARPNESS
-
+
TINT
COLOR
CONTRAST
FREEZ
0
9
7
8
6
5
43
2
1
ENTER
PAUSE
-
+
PHASE
HELP
Switching on
Use the power switch to switch on.
When '0' is visible, the projector is switched off.
When '1' is visible, the projector is switched on.
When switching on with the power switch, the projector starts in the
stand by mode. The projector mode indication lamp is red.
To start image projection :
a. press the 'Stand by' button on the local keypad or on the remote
control. The projector mode indication lamp will be green.
b. press a digit button to select an input source. The projector mode
indication lamp will be green.
RS232 OUT
IR- ACKNO WLEDGED
I R-RECE I VED
DI AG NOS TI CS
CODE
I R-RECE I VER
100 - 230 V
9 - 4 A
60 - 50 Hz
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
Projector mode indication
RS 232 IN
COMMUNICATION PORT
(800-PERIPHERALS)
RS232 OUT
0
I