Filter
Top Products
Configuring the MES1A/B
Manual Documentation Number: MES1A/MES1B-2106m PN7138-rev001
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
33
• If you configure this field for 0 it hold a single socket open to the last
remote Modbus TCP slave accessed
• If you configure this field for any value between 3 and 60 seconds, it
will close the last socket after the configured length of idle time.
Redundant Entry Retries After
The Redundant Entry Retries After field allows you to disable
redundant retries or set a maximum length of time for retries.
• If you configure this field for 0 is disables the feature.
• If you configure this field for any value between 15 seconds and 60
seconds it will set the retry period to the configure time.
Add, Delete, Exit - Select Function
The Add, Delete, Exit - Select Function field is the starting point
for managing entries in the IP Address Table.
• Type A to add an entry. The
Modbus addr from prompt appears.
• Type D to delete an entry. The
Delete entry number prompt
appears.
• Type E to exit.
Modbus Address From/To
Configuring these fields sets up the range of Modbus slave addresses that
will be forwarded to the IP address (that you will configure in the next step).
The prompt:
Modbus addr from (1) indicates that no slave addresses
have been added to the list so far. If other slave addresses have already been
configured, the number will reflect the first available slave address number.
37. Press Enter to accept
(1) as the first slave address number, or type
in the number you prefer. After you press Enter, the
Modbus
Address To prompt appears.
38. Type in an slave address number that reflects the range of slaves
that will be found at the IP address that will be entered in the next
step. When you press
Enter the Slave IP address prompt
appears.