Filter
Top Products
++
--
++
--
1
2
3
9
Preparations for the Remote Control
Insert the batteries into the remote control, and
you can use it to operate DVD player.
Open the cover
Insert batteries
Make sure to match the + and - to
the mark inside the battery
compartment.
Close the cover.
Direct the remote control at the remote sensor
of the DVD player.
Do not drop or give the remote control a shock.
Do not leave the remote control near an
extremely hot or humid place.
Do not spill water or put anything wet on the
remote control.
Do not open the remote control.
Notes on the Remote Control
Operating with the Remote Control
This section shows you how to use the
remote control.
Point the remote control at the
remote sensor and press the
buttons.
Angle: About 30°in each direction of the
remote sensor.
Do not expose the remote sensor of the
DVD player to a strong light source such
as direct sunlight or illumination. If you
do so, you may not be able to operate the
DVD player with the remote control.
Notes on Batteries
Improper use of batteries may cause battery
leakage and corrosion. To operate the remote
control correctly, follow the instructions below.
Do not insert the batteries into the remote control
in the wrong direction.
Do not leave the discarded or exhausted batteries
in the remote control.
Do not use different types of batteries together, or
mix old and new batteries.
If you do not use the remote control for a long
period of time, remove the batteries to avoid
possible damage from battery corrosion.
If the remote control does not function correctly or
if the operating range becomes reduced, replace
all batteries with new ones.
If battery leakage occurs, wipe the battery liquid
from the battery compartment, then insert new
batteries.
The battery can last for about 1 year when
normally used.
POWER
OPEN/CLOSE
11
22
33
44
55
66
77
88 99
00
MUTE
AUDIO
SUBTITLE
ANGLECLEAR
+10+10
DISPLAYTITLESEARCHRETURN
MENU PBC
SETUP VIDEO
PAUSE/STEPSTOPPLAY
FB FF
-
VOL +REPEATA-B
SLOW ZOOM PROGRAMN/P
PREV NEXT
ENTERENTER