Belkin G1V1000 8820-01176 TV Receiver User Manual


 
1
1. Getting @TV connected to your home network
The @TV setup software for PC and Mac is the best way to configure @TV.
Visit http://www.belkin.com/mytveverywhere to download the software.
a. Wired
i. Direct connection via an Ethernet cable will provide the
best possible performance for your @TV product. Simply
connect the cable to one of the open ports on your
broadband-connected network router and then to the
Ethernet port on your @TV.
ii. If you have trouble getting your @TV to connect with your
router, first make sure that the network cables are attached
properly to both devices. Then try restarting your router or
cable/DSL modem: unplug the devices for 30 seconds, plug
them back in, and they should find one another.
b. Wireless
i. In order to get your @TV onto your home wireless network,
follow the directions in the setup software.
ii. If your router is WPS (Wi-Fi Protected Setup) enabled, you
can also follow your router’s instructions for how to connect
devices to it using that feature; this will not always work
for all router/@TV combinations, but should work for most.
The red @TV WPS button is located on the right side of the
product as you face it, just next to the USB service port.
SETUP AND INSTALLATION