Filter
Top Products
Introduction8
Controls and functions
External control panel
1. Power (Refer to "Start up" on page 21 and "Shutdown" on page 26 for more infor-
mation.)
Turns the projector on or off.
2. Blank (Refer to "Hiding the image" on page 25 for more information.)
Used to hide the screen image. You can press any key on the control panel to bring the
image back.
3. Mode (Refer to "Application Mode" on page 29 for more information.)
Depending upon which input signal is selected, there are several picture setup options
available.
4. Source (Refer to "Switching input signal" on page 25 for more information.)
Sequentially selects the input signal RGB, Component Video,
S-Video or Video.
5. Auto (Refer to "Auto-adjusting the image" on page 23 for more information.)
Automatically determines the best picture timings for the displayed image.
6. Lamp indicator light (Refer to "Indicators" on page 41 for more information.)
Indicates the status of the lamp. Lights up or flashes when the lamp has developed a
problem.
7. Temperature warning light (Refer to "Indicators" on page 41 for more information.)
Flashes red if the projector’s temperature becomes too high.
8. Power indicator light (Refer to "Indicators" on page 41 for more information.)
Lights up or flashes when the projector is under operation.
9. 3 Left
10. Right 4(Refer to "Correcting keystone" on page 24 for more information.)
When the on-screen menu is not activated, #9 and #10 function as Keystone -/+ hot
keys.
11. 6Menu (Refer to "Using the menus" on page 28 for more information.)
Turns on the on-screen display control menu.
12. 5Exit
1
2
9
8
7
12
6
5
10
4
11
3
13
14
I