Filter
Top Products
15
CHAPTER 3: Installation
3.2.3 C
ONNECTING THE
C
OMPUTERS
USB Installation
1. Connect the ServSwitch DT Pro II’s USB cable’s (EHN7002021-0006) USB
connector to the PC1 USB port on the back of the ServSwitch. Connect the
cable’s VGA connector to the ServSwitch unit’s PC1 VGA connector. See
Figure 3-5.
2. Connect the cable’s male VGA and USB connectors to the corresponding
connectors on the back of the computer.
Figure 3-5. USB computer connections.
3. Repeat steps 1 and 2 for all computers.
4. Power on your computers. Your computers’ operating systems should
recognize the ServSwitch and will automatically install the USB driver if it was
not already installed on your computers.
NOTE
On some computers, you must enable USB support on your system
BIOS. Please refer to your computer manufacturer’s manual or the
motherboard manual to verify that USB support is enabled.
USB
USB, VGA, and
audio connectors
on the computer