Filter
Top Products
12
5. ILLUMINATOR UNIT RE-ASSEMBLY
Make sure the input power wires are properly
connected and tightened into the terminal block,
all holes are sealed against moisture penetration
and all mounting screws are tight.
Step 5.1 - Check the gasket attached to the
rear cover plate has not been
dislodged or warped.
Step 5.2 - Gently press the rear cover into
place, making sure the gasket is
properly seated and the photocell is
centered in its viewing window.
See Figure 5-1 on page 14.
Step 5.3 - Attach the rear cover to the housing.
Step 5.4 - Ensure the power cable has enough
slack so that it is not stressed or
crimped when the EX12LED unit is
fixed into its final mounting position.