Filter
Top Products
4
Preparing for Use
English
Installing remote control batteries
1. On the back of the remote, slide open the
battery compartment (Figure 1).
2. Insert the two supplied AA (IEC-R6) 1.5V
batteries, or their equivalent, as shown.
Match the plus (+) and minus (–) marked on
the batteries with the plus (+) and minus (–)
inside the battery compartment.
3. Slide the battery compartment cover back
into place.
Note:
Replace the batteries when the remote
control stops operating or its range seems
reduced.
Figure 1
Installing the batteries
Programming the advanced remote
Find the four-digit setup code for your cable box,
satellite box, or TV in the Appendix at the end of
this guide.
–
+
+
–
There may be more than one code listed for
your model of a particular product brand.
If you notice a lack of response or limited
functionality after programming the remote,
you may need to use a different code for
that product.
Note:
When the remote is programmed
for use with both the cable/satellite box and
the TV, the channel controls on the remote
will change channels on the cable/satellite
box and not on the TV
.
AM272394_00_pdf • October, 2003