Filter
Top Products
5
Preparing for Use
English
To control the TV
1. Turn on both the 3•2•1 system and your TV.
2. Press and hold the
Program
and
TV On/Off
buttons (shown on the left) for 3 seconds.
The remote Source buttons will light to
signal that you have entered programming
mode.
3. Use the number keys to enter your TV’s
four-digit setup code.
4. Press
Program
once to complete program-
ming. The remote will flash once to indicate
successful programming. To confirm that,
use the remote to turn your TV on and off or
change channels.
Note:
If your advanced remote flashes rapidly
several times during programming, an error has
occurred. Wait 7 seconds for the remote to clear
and begin programming again.
To control the cable/satellite box
1. Turn on both the 3•2•1 system and your
cable/satellite box.
2. Press and hold the
Program
and
Guide
buttons (shown on the left) for 3 seconds.
The remote source buttons will light to
signal that you have entered programming
mode.
3. Use the number keys to enter your cable/
satellite box’s four-digit setup code.
4. Press
Program
once to complete program-
ming. The remote will flash once to indicate
successful programming. To confirm that,
use the remote to change cable/satellite
channels.
Note:
If your advanced remote flashes rapidly
several times during programming, an error has
occurred. Wait 7 seconds for the remote to clear
and begin programming again.
Step
2
Step
2
AM272394_00_pdf • October, 2003