Filter
Top Products
D
D
D
L
L
L
P
P
P
P
P
P
r
r
r
o
o
o
j
j
j
e
e
e
c
c
c
t
t
t
o
o
o
r
r
r
—
—
—
U
U
U
s
s
s
e
e
e
r
r
r
’
’
’
s
s
s
M
M
M
a
a
a
n
n
n
u
u
u
a
a
a
l
l
l
– 88 –
The LAMP LEDs
PROJECTOR STATUS LED CONDITION LED SEQUENCE PROJECTOR CONDITION
Lamp off Off Off Lamp off
End of the lamp life Red blink
0.5 secs on
0.5 secs off
Replace lamp
No lamp
Red 1 time blink
(repeatedly)
0.5 secs on
2.5 secs off
ERROR
Lamp ERROR
Red 6 times blink
(repeatedly)
(0.5 secs ON > 0.5 secs
OFF) * 6 > 2.0 secs OFF
ERROR
Cooling lamp Orange blink
0.5 secs ON > 0.5 secs
OFF
Switching lamp1 and 2
Re-light up sequence Green blink
0.5 secs ON > 0.5 secs
OFF
Start up
Lamp life over Red on On Replace lamp
Eco mode Orange on On Power on
Normal mode Green on On Power on
Common Problems and Solutions
These guidelines provide tips to deal with problems you may encounter while using the projector. If
the problem remains unsolved, contact your dealer for assistance.
Often the problem is something as simple as a loose connection. Check the following before proceed-
ing to the problem-specific solutions.
x Use some other electrical device to confirm that the electrical outlet is working.
x Ensure the projector is turned on.
x Ensure all connections are securely attached.
x Ensure the attached device is turned on.
x Ensure a connected PC is not in suspend mode.
x Ensure a connected notebook computer is configured for an external display. (This is usually
done by pressing an Fn-key combination on the notebook.)
Tips for Troubleshooting
In each problem-specific section, try the steps in the order suggested. This may help you to solve the
problem more quickly.
Try to pinpoint the problem to avoid replacing non-defective parts.
For example, if you replace batteries and the problem remains, put the original batteries back and go
to the next step.
Keep a record of the steps you take when troubleshooting: The information may be useful when call-
ing for technical support or for passing on to service personnel.