Filter
Top Products
PAGE 20
Recall
In TV mode, press【RECALL】to return the previous channel or the previous signal source.
Zoom Mode
Switch between Fill screen, 4:3, Wide, Cinema and Subtitle.
Still
Press【STILL】to freeze or activate the current image.
PIP/POP/PBP Function
Press
to enter into or exit from the sub-picture mode.
1. Press
to choose sub-picture signal source of TV, AV, AV1, AV2, YPbPr, PC and DVI.
2. Press
to choose the sub-picture mode of PIP, PBP and POP.
● Mode 1: To overlap a sub-picture (PIP) in small size
● Mode 2: To place two pictures of the same size side by side. Both main picture and
sub-picture (PBP) cover half of the display screen area.
● Mode 3: A main picture covers 12/16 area of the display screen while a sub-picture
(POP) covers 1/16.
3. Press
to switch between the main picture and sub-picture.
4. Press
to freeze or continue the program of the current sub-picture.
5. Press to adjust the sub-picture position.
To switch the sub-picture’s channels while in TV mode, pressing 【CH+】/【CH-】.
The sub-picture can enter into TV mode directly by pressing 【CH+】/【CH-】 in other modes.
The below table illustrates the possible combination of different modes when in
PIP/POP/PBP Function.
Main Pic
Sub Pic
TV AV(CVBS) AV(Y/C) AV1(CVBS) AV1(RGB) AV2(CVBS) AV2(Y/C) PC DVI YPbPr
TV
● ● ● ● ● ● ● ● ● ●
AV(CVBS)
● ●
● ● ● ● ● ● ●
AV(Y/C)
●
● ● ● ● ● ● ● ●
AV1(CVBS)
● ● ● ●
● ● ● ● ●
AV1(RGB)
● ● ●
● ● ●
●
AV2(CVBS)
● ● ● ● ● ●
● ● ●
AV2(Y/C)
● ● ● ● ●
● ● ● ●
PC
● ● ● ● ● ● ● ● ●
DVI
● ● ● ● ● ● ● ● ● ●
YPbPr
● ● ● ● ● ● ●
● ●
Note: All buttons mentioned in this operation are on the remote control, signs of “●” mean
that both pictures can be displayed at the same time and the blanks mean that both modes
can not be displayed at the same time.