Filter
Top Products
Scorpion™ GBC 2.0/RGY User Manual (Rev. 2 ML) Page 11 of 52
Mounting
Orientation
The Scorpion™ GBC 2.0 and RGY units may be mounted in any position, provided
there is adequate ventilation.
Rigging
Be sure that the structure onto which you are mounting this product can support its
weight. See the Technical Specifications section of this manual for weight information.
Mount the product securely. You can do this with a screw, a nut, and a bolt. You could
also use a mounting clamp if rigging this product onto a truss. A
lways use a safety
cable. Consider ease of access to the unit for maintenance and programming purposes
before deciding on a location for this product
When power linking multiple products,
always consider the length of the power linking
cable and mount the products close enough together for cables to reach.
The bracket adjustment knobs allow for aiming the product to a desired angle. Do not
use tools to loosen or tighten the bracket knobs because tools can damage them.
Mounting Diagram
Proper Use
This product is for overhead mounting only. For safety purposes, CHAUVET®
recommends mounting your lighting effect products on steady elevated platforms or
sturdy overhead supports using suitable hanging clamps. In all cases, you must use
safety cables. You can obtain appropriate mounting hardware from your distributor.
International laser safety regulations require that laser products must be operated in the
fashion illustrated below, with a minimum of 3 meters (9.8 ft) of vertical separation
between the floor and the lowest laser light vertically. Additionally, 3 meters of horizontal
separation is required between laser light and audience or other public spaces.
Hanging Bracket
Bracket Adjustment
Knob (1 of 2)
Safety Loop
CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THA
N THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.