Filter
Top Products
Precautions
Precautions
Make certain that the remote is installed in a location which
does not interfere with the safe and proper operation of the
boat.
The
CMRCI-BSS/SB
is only compatible with the
CMD4 or
M455 / XMD3
AM/FM/CD Player.
About Installation
About Installation
Installation of Clarion Marine audio components requires expe-
rience with a variety of mechanical and electrical procedures.
Even though this Manual provides general installation and op-
eration instructions for your new Clarion Marine audio remote
control panel, it does not show the exact methods which may
be required for your particular installation.
If you do not have the required knowledge and experience to
successfully complete the installation, we strongly recommend
consulting an authorized Clarion Marine audio dealer about
professional installation options.
Table of Contents
Table of Contents
Page
Page
1. Introduction
....................................................................
4
2. Care and Maintenance
..................................................
4
3. Using the Remote Control Panel
..................................
5
4. Installation and Wiring
..................................................
7
5. Limited Warranty Information......................................11
10 CMRCI- BSS/SB
2.
Connecting the illumination lead.
The illumination circuit of the CMRCI-BSS/SB operates with
a +12V input. Wire with a .250 female insulated spade
terminal (not supplied), and connect the illumination
terminal on the rear of the panel to a 0.5A in-line fuse (not
supplied). Connect the other side of the fuse to an
illumination circuit boat.
3. Connecting the cables.
Connect the DIN cable from the
CMD4
or M455
AM/FM/CD
to the remote(s). Route it carefully to avoid moving parts.
M101RXC
M101RXC
M101RXC
M101RYC
CMRCI-BSS/SB
CMCI-BSS/SB
CMRCI-BSS/SB
Connecting one remote to the CMD4 or M455
with optional M101RXC DIN cable.
Connecting two remotes to the CMD4 or M455 using an
optional M101RYC and two M101RXC DIN cables.
NOTE: A maximum of two remotes can be connected
to the CMD4 or M455.
CMRCI- BSS/SB
3
CMD4
or
M455
CMD4
or
M455