Filter
Top Products
System Setup
2.2. DIGITAL AUDIO SETUP
2.2.1 DIGITAL OUTPUT
SPDIF OFF: There will be no digital audio signal output. (Coaxial Off)
ALL: The digital audio signal output will be in its raw format. Normally, this m ode is used for DTS & Dolby Digital
5.1 signals.
PCM ONLY: The digital audio signal output will be in PCM format. Normally, this mode is used for audio CD signals.
2.2.2 LPCM OUT
When DIGITAL OUTPUT is set to PCM ONLY, this item is available.
Select a sample rating for the analog audio output. There are two options, 48KHz and 96KHz.
NOTE: Some amplifiers don't support 96KHz sampling which will affect the optical and coaxial output.
2.3 DOLBY DIGITAL SETUP
2.3.1 DUAL MONO
STEREO: The player outputs the left-channel audio and right-channel audio via the FL and FR speaker
respectively.
L-MONO: The player outputs the left-channel audio only via both the FL and FR speaker.
R- MONO: The player outputs the right-channel audio only via both the FL and FR speaker.
MIX- MONO: The player
outputs the average signal of the left-channel and right-channel audio via the FL speaker
and the FR speaker.
NOTE: This function only applies to the Dolby AC -3 encoded 2-channel discs.
2.3.2 DYNAMIC
When you watch films with large dynamic scope in low volume, for example at night, you can adjust the dynamic
value up to avoid losing sound details resulting from the low volume.
3 VIDEO SETUP PAGE
3.1 VIDEO OUTPUT
OFF: Set video output to the CVBS.
YUV: Set video output in analog component video format if the component video outputs are used.
P_YUV: Set video output as progressive YUV signals if the component video outputs are used.
NOTE: If the video setting differs from the actual video connection, you may get no image or very poor image on the
TV. In such reset this setting item for an appropriate video output mode or press [V-MODE] on the remote
control until the output image becomes normal.
cases
-12-