Filter
Top Products
Helpline No.UK/Northern lr ela nd 0800 032 5264 Rep. lr eland 1800 315 697
W eb S upport www.curtisint.com
Model Number: DVD3602UKT
2
Helpline No.UK/Northern lr ela nd 0800 032 5264 Rep. lr eland 1800 315 697
W eb S upport www.curtisint.com
Model Number: DVD3602UKT
19
12
13. OUTDOOR ANTENNAGROUNDING
14. LIGHTNING
15. POWER LINES
16. OVERLOADING
17. OBJECT AND LIQUID ENTRY
18. SERVICING
-Ifan
outside antenna or cable system is connected to
the product, be sure the antenna or cable system is
grounded so as to provide some protection against
voltage surges and built-up static charges.
Below diagram provides information with regard to
proper grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
location of antenna-discharge unit, connection to
grounding electrodes, and requirements for the g
rounding electrode. See Figure 1.
- For added protection for this
product during a lightning storm, or when it is left
unattended and unused for long periods of time,
unplug it from the wall outlet and disconnect the
antenna or cable system. This will prevent damage
to the product due to lightning and power-line surges.
- An outside antenna system
should not be located in the vicinity of overhead
power lines or other electric light or power circuits,
or where it can fall into such power lines or other
electric light or power circuits. When installing an
outside antenna system, extreme care should be
taken to keep from touching power lines or circuits
as contact with them might be fatal.
- Do not overload wall outlets,
extension cords, or integral convenience receptacles
a s this can result in a risk of fire or electric shock.
- Never push
objects of any kind into this product through
openings as they may touch dangerous voltage
points or short-out parts that could result in a fire or
electric shock. Never spill liquid of any kind on the
product.
- Do not attempt to service this
product yourself as opening or removing covers may
expose you to dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
. NONUSE PERIODS - The power cord of the
product should be unplugged from the outlet when
left unused for long periods of time.
19. DAMAGES REQUIRING SERVICE
20. REPLACEMENT PARTS
21. SAFETY CHECK
22. HEAT
23.
24.
25.
26.
27.
28.
29.
-
Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the
following conditions.
a) When the power-supply cord or plug is damaged.
b) If liquid has been spilled, or objects have fallen
into the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by
following the operating instructions. Adjust only
those controls that are covered by the operating
instructions as an improving adjustment of other
controls may result in damage and will often
require extensive work by a qualified technician
to restore the product to its normal operation.
e) When the product exhibits a distinct change in
performance - this indicates a need for service.
- When replacement
parts are required, be sure the service technician
has used replacement parts specified by the
manufacturer or have the same characteristics as
the original part, Unauthorized substitutions may
result in fire, electric shock or other hazards.
- Upon completion of any
service or repair to this product, ask the service
technician to perform safety checks to determine
that the product is in proper operating condition.
- The product should be situated away
from heat sources such as radiators, heat registers,
stoves or other products (including amplifiers) that
produce heat.
Keep minimum distances (5cm) around the apparatus
for sufficient ventilation.
The ventilation should not be impeded by covering the
rear panel for ventilation with items, such as newspapers,
table-cloths, curtains, etc.
No naked flame sources, such as lighted candles,
should be placed on the apparatus.
Don’t use the apparatus in tropical climates.
Where the mains plug is used as the disconnect
device, the disconnect device shall remain readily
operable.
The apparatus shall not be exposed to dripping or
splashing and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
Attention should be drawn to the environmental
aspects of battery disposal. Don’t throw used batteries
in dustbin. Please contact your retailer in order to
protect the environment.
ANTENNA
LEADWIRE
ANTENNADISCHARGEUNT
POWERSERVICE GROUNDING
ELECTRODESYSTEM
GROUDCLAMP
GROUNDINGCONDUCTORS
GROUND
CLAMP
ELECTRIC
SERVICE
SQUIPMENT
EXAMPLEOFANTENNAGROUNDING
IMPORTANT SAFETY INSTRUCTIONS
TROUBLESHOOTING
Check the chart below for a possible cause of the problem you are experiencing before requesting
service for this unit, Some simple checks or minor adjustment on your part may eliminate the problem
and restore proper operation. Let the technician maintain the unit. Keep away from static electricity
properly before maintenance as loader, key IC are easy to be damaged by it.
Suggested solution
Plug the power cord into the power outlet tight to turn on/off once
Disc access time within 10-20 seconds is normal
The disc is scratched or defiled (change disc)
The code of disc is different from the code of unit (change the disc)
PAL to NTSC error (Set video output as AUTO)
If your TV does not have P-Scan function, pressing VIDEO button on the
remote may cause this. Press VIDEO button again to rectify.
Ensure that the equipment is connected properly.
Ensure that the TV or audio equipments are not muted.
Ensure that the audio output setting is correct.
The picture will be somewhat distorted at times.
This is normal advance or reverse.
Choose the correct setup at TV TYPE item that matches the TV set.
Check the batteries being installed with correct polarities.
Replace the batteries depleted. Point at remote control sensor and
operate it within 5 meters.
Turn the unit off and then back to on. Alternatively, turn off the unit,
disconnect the AC power cord for 5 to 10 minutes and then reconnect it.
If the audio soundtrack and/or subtitle language does not exist in the
disc, the language selected at the initial settings will not be seen/heard.
Alternative audio soundtrack (or An alternative language is not selected
with discs which contain subtitle) language cannot be more than one
language selected.
This function depends on software availability.
Even if a disc has a number of angles recorded,
these angles may be recorded for specific scenes only.
This function is suitable for VCD with playback control disc.
In program playing mode, no repeat, A-B functions are available.
No power
Cannot read disc
No picture
No sound
Picture is distorted
during fast forward or
reverse
No (4:3)(16:9) picture
Remote control does
not function
Unit s or remote
control buttons are
not functioning or
other abnormal
phenomena
Audio soundtrack and/
or subtitle language
not found in settings
Can not change angle
No playback menu
Miscellaneous
Trouble
,