Filter
Top Products
CH-DVD 500
ON / OFF
STANDBY
OPEN / CLOSE
Operation of Remote Control
When using the control, please aim at the device's remote control sensor, located in the DVD
R03 1.5V
Installing the Batteries
If the remote control only operates when you get closer to the DVD Player, it may mean the batteries are weak.
Please replace the two batteries simultaneously with two new batteries (Size AAA, R03, 1.5V) of the same type.
Please note the positive (+) and negative (-) polarity shown inside the battery compartment on the remote.
Important Note about Batteries
When changing batteries, it is not recommended to use a mix old and new batteries or batteries of different
brands simultaneously.
If the unit will not be used for an extended length of time, it’s wise to remove the batteries before storage.
The life of the batteries depends on the amount of usage. With typical use, a battery life of approximately 6
1. Push down and then outwards to
remove the battery compartment cover.
2. Insert Batteries following polarity
marked inside compartment.
3. Slide Cover back into place.
30
30
Preparing and Using the Remote Control
6
Quick Tips
Make sure no objects
are between the remote
and the player.
Similar remote controls
could interfere with the
function of the player.
Make sure not to store
the remote upside
down or with any
objects pressing on the
buttons - this could
drain the battery.
5
4
6
C
+10
2
1
3
8
7
9
0
ZOOM
EFFECT
1/ALL
REPEAT
RETURN
SLOW
SUBTITLE AUDIO ANGLE
POWER
GOTO
PBC
SETUP
OPEN/CLOSE
TITLE
DISPLAY
PROG
MENU
A-B
BOOKMARK
INTRO
PAUSE
ENTER
PLAY
STOP
MUTE