Filter
Top Products
SETUP
23
Initial Setup
1
Press [SETUP]. The Setup menu appears.
While ‘Init Setup‘ is selected, press [ENTER] to go to the initial setup
page.
2
Use [œ/√] to select ‘Preferences ‘.
3
While ‘Preferences ‘ is selected, press [†] to select ‘Audio‘.
4
Press [√]. The ‘Audio‘ submenu is displayed.
Digital Output
1
Use […/†] to select ‘Digital Output‘ while the Audio submenu is
displayed.
2
Press [√] to go to the second level.
3
Use […/†] to select the desired digital output type.
4
Press [ENTER] to confirm your selection.
5
Press [SETUP] to exit the menu.
Off
No signal will be output from the Digital Audio Out jacks.
Bitstream
Select when connected to a Dolby Digital or DTS decoder (or an amplifier or other equipment with a Dolby
Digital or DTS decoder).
LPCM
Select when connected to a digital amplifier. The DVD Recorder+VCR's digital audio signal will be output in the
PCM format when you play a DVD recorded with a Dolby Digital (only for DVD) or MPEG soundtrack. If the DVD
is recorded with a DTS sound track then no sound will be heard.
Dynamic Range
While watching DVD movies, you may wish to compress the dynamic range
of the audio output (the difference between the loudest and quietest
passages). This allows you to listen to a movie at a lower volume without
losing clarity of sound.
Set 'Dynamic Range'to anymode you want for this effect.
Follow the same procedure as ‘Digital Output‘ to set the Dynamic Range.
‘Preferences’ / Audio Settings
Preferences
Video
•Audio Digital Output BItstream
Parental Ctrl Dynamic Range
Auto Settings
VCR
Modulator Out
Choose OK Exit
ENTER SETUP
œ √
…
†
Preferences
Video
Audio Digital Output
Parental Ctrl Dynamic Range – – FULL
Auto Settings – –
VCR – – 1/2
Modulator Out – –
– – OFF
Choose OK Exit
ENTER SETUP
œ √
…
†
Preferences
Video
Audio • Digital Output Off
Parental Ctrl Dynamic Range Bitstream
Auto Settings LPCM
VCR
Modulator Out
Choose OK Exit
ENTER SETUP
œ √
…
†
DF-T35-37D2P-WB 2006.8.24 4:57 PM ˘ ` 23 mac001 1200DPI 90LPI