Filter
Top Products
25
MUTE
PICTURE
P.MODE
STILL
DYNAMIC BASS 3D-PANORAMA P.PR
P. P R
LOCK SLEEP
P.STILL P.SWAP P.INPUT
ASPECT
SOUND
POWER
RECALL
PREV PR OK
MULTIMEDIA
MENU
V
O
L
V
O
L
PR
PR
1 23
4 56
7 89
0
X
?
Parts of the remote
controller
18. DYNAMIC BASS : Using this button, you can enhance the bass.
19. 3D-PANORAMA : Using this button, you can listen to the virtual sur-
round sound.
20. : When sub screen is RF(TV) mode in the POP, you can change
PROGRAMMES using this button.
21. : You can select sound mode in Mono, Stereo, Dual1, Dual2,
NiCAM STEREO. It works only in TV mode.
22. STILL : Press this button to freeze the picture.
23. NUMBER : Press the numbers on this board, you can select PR directly
in TV mode.
Note:
When the current state is ST-BY, you can turn on the TV using a digit
key. Then, a PROGRAMME is selected according to digit number.
24. LOCK : This prevents the use of the TV set without the remote control.
25. SLEEP : Sleep Timer setting.
SLEEP TIMER : OFF => 10 => 20 => 30 => 40 => 50 => 60 => 70 => 80 =>
90 => 100 => 110 => 120 => OFF
26. Teletext : see page 47.
Inserting Batteries into the Remote Control Unit
To load the batteries, turn the remote control handset over and open the
battery compartment. Insert the batteries (Two 1.5v, type AAA).
Make sure that the polarity matches with the (+) and (-) marks inside of
the battery compartment.
Note :
To avoid damage from possible battery leakage, remove the bat-
teries if you do not plan to use the remote control handset for
an extended period of time.