Filter
Top Products
24
POWER
MULTI
MEDIA
MUTE
DVB/Analog
AV NORMAL
VOL PR / PAGE
VOL
CANCEL / EXIT MENU
M
ASPECT
GUIDE
SUBTITLE LANGUAGE FAVOURITE
RECALL S.EFFECT
ABC DEF GHI
JKL MNO PQR
STU VWX YZ&.
STILL
SLEEP
TEXT REVEAL T.CANCEL SIZE
S-CODE HOLD MIX INDEX
P.MODE P.STILL P.SWAP P.PR▲
P.INPUT P.SIZE P.PR▼
PR / PAGE
OK /
SELECT
123
456
78
0
9
Parts of the
Remote Controller
22. NUMBER : Press the numbers on this board, you can select pro-
grammes directly in TV mode.
Note :
When the current state is ST-BY, you can turn on the TV
using the digit key. Then a PROGRAMME is selected according to
digit number.
23. STILL : Press this button to freeze the picture.
Note
: „STILL” function is not available in PC mode and PC reso-
lution of HDMI mode.
24. SLEEP : Sleep Timer setting.
SLEEP TIMER : OFF 10 20 30 40 50 60 70 80
90 100 110120 OFF
25. TELETEXT : see page 46.
26. P.MODE : Each time you press this button, the TV will cycle through:
POP PIP OFF
27. P.STILL : Using this button, you can still the sub screen in POP or
PIP mode.
28. P.SW AP : Using this button, you can swap the main screen for sub
screen.
29. P.INPUT : Sub Screen input mode change as follows POP or PIP ta-
ble mode. See page 38.
30. P.PR : When sub screen is RF(TV) mode in the POP or PIP, you
can change the programme using this button.
Inserting Batteries into the Remote Control Unit
To load the batteries, turn the remote control handset over and open
the battery compartment. Insert the batteries (Two 1.5v, type AAA).
Make sure that the polarity matches with the (+) and (-) marks inside
the battery compartment.
Note :
To avoid damage from possible battery leakage, remove the
batteries if you do not plan to use the remote control hand-
set for an extended period of time.