Filter
Top Products
22
CIRCUIT OPERATION
TAPE END OUT
When the recording tape ends during recording, end sensor will be detected. This port is used Alarm to outsider until
release the end sensor detecting.
SW OUTPUT
This port is used triggering video signal with external equipment during recording.
SERIES OUTPUT
When the series recording proceeds after setting the series recording to “on”, this port is used to output the control signal
to the set which will be recorded continuously after pre-recording set.
0V
END Detect END Detect
HIGH
LOW
5V
4ms
SW
OUT
2FIELD
16.67ms
SW
OUT
1FIELD
VIDEO
SIGNAL
0V
250ms
5V