Filter
Top Products
18
© 2008 Directed Electronics. All rights reserved.
Using the system
➤ Arming the system
To arm the system, press the
A U X
button on the remote control.
The siren in the vehicle will “chirp” once and the parking lights will flash
once. If the power door locks have been connected, the doors will
lock. The system will automatically check for errors when it arms.
If errors are found when arming:
If an alarm trigger zone – such as a door, the trunk, the hood, or a
sensor, was active at the time of arming, the system will “bypass”, or
ignore, this trigger zone. This allows the system to continue to protect
your vehicle using the remaining trigger zones.
You are notified of this active zone immediately after arming the system.
The siren in the vehicle will “chirp” again and the parking lights will
flash again. The Status LED indicator in the vehicle will blink in a pattern
to indicate the active zone number error which was found (See Table
of Zones on page 34).
Arming without the chirp (Silent Arm):
Press the
AUX
button at the bottom of the remote once, and then press
the
A U X
button. The system will arm without the confirmation chirp. The
parking lights will flash once.
➤ While the system is armed
Fail-Safe Starter Kill•
The starter is disabled by the system’s Fail-Safe starter kill (if installed).