Directed Electronics 2.2 Universal Remote User Manual


 
29
© 2008 Directed Electronics. All rights reserved.
does not remote start until the MTS sequence is re-initiated.
Note: An optional push button can be hard wired to the (-) activation
input (H1/10) on the remote start. This allows the user to activate the
turbo timer without having to use the remote.
When the vehicle is running follow the procedures listed above, but
instead of pressing the remote, press the push button the appropriate
number of times to activate the remote start (factory setting is for 1
pulse). Turn off the ignition and exit the vehicle. The car remains running
for the pre-programmed amount of time.
Smart start
With Smart Start you can activate remote start when the vehicle reaches
a certain temperature, or when it reaches a certain voltage.
The factory setting for temperature high is 100º, and the low is 0º (F).
The voltage setting is 10.5v. These settings can be adjusted or turned
off by your installer using the Bitwriter.
To activate Smart Start mode:
Press the
AUX
button on the remote 3 times and then press the
AUX
button.
The parking lights flash 5 times fast to confirm the remote is in Smart
Start mode.
To activate Smart Start mode with a manual transmission:
Enter the MTS procedure.1.