Filter
Top Products
26
© 2008 Directed Electronics. All rights reserved.
➤ Manual transmission vehicles
If the vehicle has manual transmission the proper steps must be fol-
lowed before leaving the parked vehicle or the remote start feature is
disabled.
Put the transmission in neutral.1.
Press on the vehicle’s foot brake.2.
Apply the emergency brake.3.
Release the vehicle’s foot brake. 4.
Note:
Pressing the brake again
after this step will disable the remote start feature.
Within 15 seconds activate the remote start from the remote.5.
The parking lights will flash 5 times confirming that the remote start 6.
is active.
Turn off the ignition (the car should stay running when key is turned 7.
off).
Exit the vehicle and close the door.8.
Arm the alarm (the vehicle should shut off when arming the sys-9.
tem).
You can now remote start the vehicle. If a door is opened or if the alarm
is triggered before the next remote start activation the system will not
remote start.
To drive your vehicle after it has been remote started:
Get in without stepping on the brake. 1.
Insert the ignition key and turn it to the ON position.2.
Now, step on the brake.3.