Dish Network 159263 Universal Remote User Manual


 
5
SCANNING FOR EQUIPMENT CODES
Instructions Additional Information
1 Turn the equipment on. Use the equipment’s front panel
buttons or its own remote
control.
2 Press and hold the mode
button until all the other
mode buttons light up, and
then release the button. The
mode button flashes.
For example, hold the TV mode
button for a TV until all of the
other mode buttons light. When
you let go, TV will flash.
3 For AUX mode only. Press
0 for a second TV, 1 for a
second DVD/VCR, or 2 for
a tuner, amplifier, or audio
receiver. Then press the
STAR (*) button.
This step is for programming
the kind of equipment that
should be programmed in AUX
mode. If you’re not
programming in AUX mode,
skip to step 4.
4 Press POWER. This puts your remote control in
its code scanning mode.
5 Press either the UP or
DOWN ARROW
repeatedly until the
equipment turns off.
As you press the UP or DOWN
ARROW, the remote tries each
code in the memory to see if it
can turn off your equipment.
When the equipment turns off,
you have found a code that
might work.
Note: The mode button for the
equipment will flash rapidly
eight times when you’ve
scanned through all the codes
for that equipment.
6 Press POUND (#). The mode button flashes three
times if you have entered the
code correctly. This stores the
code that you found.