Dish Network 159263 Universal Remote User Manual


 
16
6 Use the ARROW buttons to move the highlight to the TV1
remote address (the Rem Addr box as shown below). This is
important—if you do not move the highlight, your remote control
will change the receiver's TV2 remote address (the Rem
Addr box) and cause your Remote Control 1 to control the TV2
side of your receiver.
7 Press the RECORD button on the green TV1 remote control you
are setting up. If you get a warning that tells you to pick another
address, continue on to the next step. If no warning appears, go to
step 12 of this procedure.
8 On the remote control, press and hold the SAT mode button for
about three seconds, until all the mode buttons light up, and then
release the SAT button. The SAT mode button will blink.
9 Use the number buttons to enter any number from 1 to 28, except
for the address shown for on your screen.
Write down the number you entered:
10 Press the POUND (#) button. If you entered the address correctly,
the SAT mode button will flash three times. Press RECORD on
the remote.
11 Make sure the System Information screen shows UHF and
that this address matches the number that you entered in step 9.
12 Select Done to close the System Information screen. If
nothing happens, press RECORD, and then select Done.
h
i
Device
Rem Addr
TV Ch Out
3
5
T
UHF
i
Note: Highlight the Rem Addr (the lighter area in the
graphic above).