Dish Network 159263 Universal Remote User Manual


 
8
READING OUT CODES
These instructions explain how to check the remote control code you
put in the remote control when you set it up. Be sure to write them in
the spaces provided on the inside back cover.
Instructions Additional Information
1 Press and hold the mode
button for the equipment
you want the remote control
to operate. When all the
mode buttons light up,
release the button—the
selected mode button
should now be flashing.
For example, hold the TV mode
button for a TV until all of the
other mode buttons light. When
you let go, the TV mode light
will flash.
2 Press the POUND (#)
button twice. The mode
button flashes the number
for each digit of the
equipment code, with a
pause between the groups
of flashes. A quick flash is
for zero.
For example, if the code is 570,
the mode button flashes five
times, pauses, flashes seven
times, pauses, and flashes once
quickly.
For AUX mode, the first
group of flashes tells you
what the AUX mode
controls, then the following
flashes tell you each digit
of the equipment code. A
quick flash (zero) before
the three-digit code is for a
TV; one regular flash is for
a DVD player or VCR; and
two flashes is for a tuner,
amplifier, or audio receiver.
For another satellite
receiver programmed in
AUX mode, the group of
flashes tells you the second
receiver’s address number.
For example, if the TV code is
570, the AUX mode button
flashes once quickly (indicating
the AUX equipment is a TV),
pauses, flashes five times for
the first digit of the code, then
pauses, flashes seven times for
the second digit of the code,
pauses again, and flashes once
quickly for the final digit (zero)
in the code.
For example, if the AUX mode
button is set to control a
satellite receiver with address 5,
the AUX mode button flashes
five times.