Filter
Top Products
Chapter 11
96
Connecting Over-the-Air Antenna
Scanning for Over-the-Air Channels
With your over-the-air antenna adjusted for best reception, use these instructions to scan for over-
the-air channels for the nearby TV.
1 Make sure you have your over-the-air antenna connected to the receiver’s 8VSB TV Antenna/
Cable connection.
2 Press MENU, select System Setup (6), and then Local Channels (9) to open the Local Channels
screen. If this is the first time you have opened this screen, it will have no channels listed.
3 Scan for channels by selecting Scan Locals.
4 The scan will take a few minutes to complete. When it finishes, the results will show how many
channels the scan found.
5 Select OK to go back to the Local Channels screen.
Note: If the channel number says None, you have not yet assigned this channel a network
affiliation or name. The Arrow at the bottom left means that there are more channels, off the
bottom of the screen, which you can get to with the ARROW keys if you wish to edit their names or
remove them.
6 If you want to name the over-the-air channels, continue on. If you do not want to name your over-
the-air channels, select Done. You will then be taken out of the menus back to watching TV.
7 Select a channel and then select Edit Name to modify the way the channel name displays on your
screen.
8 Use the virtual keyboard on the screen to select the letters of your channel name.
9 When you are finished making changes, select Done.
Chapter 11 Two Color.fm Page 96 Wednesday, August 2, 2006 1:00 PM