Filter
Top Products
Receiver and Remote Controls
23
Tips
TIPS
• You can use the Front Panel Locks to prevent the mode from being changed
accidentally. See page 47 for instructions.
• The only way to turn off the TV2 outputs is by using POWER on Remote
Control 2.
• In Dual Mode, Remote Control 1 is used to control TV1 menus on the nearby TV.
Remote Control 2 is used to control TV2 menus on the remote TV(s).
• If you do not do anything in a menu for several minutes, the menu automatically
closes. This will discard any changes you made, and display the program you were
watching.
• To use Remote Control 2, be sure to attach the UHF Remote Antenna. See page 15
for details.
• On Remote Control 2, press FORMAT/* to change the aspect ratio (display shape) of
HD channels displayed on remote TV(s).
QUESTIONS
• Why put the receiver in Single Mode? So you can use the PIP functions. While the
receiver is in Single Mode, you can watch the same program on all the TVs connected
to the receiver.
Chapter 02 Two Color.fm Page 23 Tuesday, July 25, 2006 3:02 PM