Filter
Top Products
Connections and Setup
89
Connecting to the Remote TVs (TV1 or TV2)
5 If your TV is in over-the-air mode for the channels you picked in step 4, circle “Air” below.
If your TV is in cable mode for the channels you picked in step 4, circle “Cable” below. If
you are using these instructions for TV1 and TV2, pick different channels (for example,
Channel 60 for TV1 and Channel 64 for TV2).
6 Set all of your remote TV(s) to the channel mode (Air or Cable) you wrote in step 5.
7 Tune all of your remote TV(s) to the channel(s) you wrote in step 5. This is the channel
you will use to receive your satellite programming.
8 Connect CH 21-69 Out on the receiver to your existing wall cable outlet using a coaxial
cable.
Note: If you do not have an existing in-home cable system, you will need to run coaxial
cable to each TV in other rooms. If this is too difficult, you may want to contact a
professional to do this installation.
9 Place the yellow sticker on the CH 21-69 Out cable near where the cable attaches to the
receiver. The stickers are located inside the front cover of this guide.
10 Turn on the nearby TV (the TV that gets programming from the TV1 outputs).
11 Make sure the receiver's green TV1 indicator is on.
12 Press MENU. Select System Setup (6), Installation (1), and then Modulator Setup (5).
13 With the Modulator Setup screen displayed on the nearby TV, use Remote Control 1 to do
the following:
a Under TV2 Out (or TV1 Out), select either Air (for over-the-air channel numbers) or
Cable (for cable channel numbers) based on what you wrote down in step 5.
b Under TV2 Out (or TV1 Out), use the UP and DOWN ARROWS to change the modu-
lator channel to the one you wrote in step 5.
c Select Done.
Note for TV1 Out: If you locked the receiver, a message will display asking you to
enter your password.
14 For some TVs, you must run a channel scan so that the TVs will find and display the
selected channel from the receiver. Run channel scan on all remote TV(s), if available.
See your TV user’s guide for instructions.
15 Confirm that you see a picture from the receiver on your remote TV(s).
• If your picture looks good, go to step 21.
TV1 Channel:
Air/CableTV2 Channel:
Chapter 11 Two Color.fm Page 89 Wednesday, August 2, 2006 1:00 PM