Filter
Top Products
118866 7
SETTING UPTHEREMOTE TO CONTROL YOUR TV
1. Find the brand name of your TV in the TV code
tables starting on page 32. You will be referring to
this location for codes in the instructions below.
2. Turn on your TV.
3. Press and hold until both lights turn
on (it takes about five seconds).
4. Release . light will flash.
5. Press . Notice light turns on and stays on.
6. Enter one of the three-digit codes for your TV from
the TV code tables while light is on.
Note: You have about 20 seconds to begin entering
the TV code.
7. Press the
MUTE button and watch light.
If light flashes three times, the code is valid
and you can go to step 8. If light does not flash
at all, the code may not have been entered
correctly. So, start over from step 3 and try the code
again.
8. Press and your TV should shut off. If your TV
shuts off, go to step 9. If not, pick another code for
your TV brand from the TV Codes table and go
back to step 3. If you have tried all of the codes and
none work, go to How to Scan for TV and VCR
Codes on page 21.
9. Turn your TV back on by pressing again and
try the other buttons below to make sure they work.
• Press the 0 through 9 buttons to change channels
on your TV.
SAT
TV
TV
TV
TV
TV
TV
TV
TV
TV
TV