Filter
Top Products
15
DVD26 DVD AND CD PLAYER USER GUIDE
SETTINGS IN THE SETUP MENU
About PAL
Most models of the newly developed countdown PAL TV
system detect 50 Hz (PAL)/60 Hz (NTSC) and au to -
mat i cal ly switch vertical amplitude, resulting in a display
without vertical shrinkage.
If your PAL TV does not have a V-Hold control, you
may not be able to view NTSC disc because the picture
may roll. If the TV has a V-Hold control, adjust it until
the picture stops rolling. On some TVs, the picture may
shrink vertically, leaving black bands at the top and bot-
tom of the screen.This is not a malfunction; it is caused by
the NTSC -> PAL conversion.
Angle Indicator
•
Default setting: ON
Activates and deactivates the
indicator. When set to
On, the
indicator appears on the front panel display
when playback of a scene recorded from multiple camera
angles is in progress.
If you prefer not to see the camera icon on-screen during
multiangle scenes on DVD discs, change this setting to
‘Off’.
Video out
•
Default setting: VIDEO
If you make a setting here that is incompatible with your
TV, the TV may not display any picture at all. If this hap-
pens either switch everything off and reconnect to the TV
using either a composite video cable, or an S-Video cable,
or reset the unit.
Option
Description
Video
Compatible with all TVs, but lowest quality of the three AV
settings.
YUV
Almost the same quality as RGB, but can give better results.
For use with the 21-pin SCART and Component Video out.
(See pos. K and L in illustr. page 3)
RGB
If your TV is compatible, this setting gives the best
picture quality.
For use with the 21-pin SCART and Component Video out.
(See pos. K and L in illustr. page 3)
MOVE SETUP:Exit
AUDIO
VIDEO OUTPUT SETUP
TV-SCREEN
TV-SYSTEM
VIDEO OUT
ANGLE INDICATOR
SCREEN SAVER
BACKGROUND
4:3 / LB
PAL
VIDEO
YUV
RGB
BLACK
VIDEO SETUP LAN GEN PROG
MOVE SETUP:Exit
AUDIO
ANGLE MARK ON/OFF
TV-SCREEN
TV-SYSTEM
VIDEO OUT
ANGLE INDICATOR
SCREEN SAVER
BACKGROUND
4:3 / LB
PAL
VIDEO
ON
OFF
BLACK
VIDEO SETUP LAN GEN PROG
Screen Saver
•
Default setting: ON
If a constant image is displayed on a conventional CRT-
type TV, it can “burn in” leaving a ghost image on the
screen. Switch to ‘On’ to make sure that a constant image
is not displayed for a dangerously long time.
MOVE SETUP:Exit
AUDIO
SCREEN SAVER SETTING
TV-SCREEN
TV-SYSTEM
VIDEO OUT
ANGLE INDICATOR
SCREEN SAVER
BACKGROUND
4:3 / LB
PAL
VIDEO
ON
ON
OFF
VIDEO SETUP LAN GEN PROG