Filter
Top Products
12
Making connectionsDX-24L230A12/DX-32L220A12/DX-46L261A12
Connecting an antenna or cable TV (no
box)
To connect an antenna or cable TV (no box):
1 Turn off your TV and all connected equipment.
2 Connect a coaxial cable (not provided) to the
ANT/CABLE IN jack on the back of your TV and to
the antenna or cable TV wall jack.
3 Turn on your TV, then go through the setup wizard
on page 18.
Connecting a DVD or Blu-ray player
To connect a DVD or Blu-ray player:
1 Make sure that your TV’s power cord is unplugged
and the DVD or Blu-ray player is turned off.
2 Connect an HDMI cable (not provided) to the HDMI1
or HDMI2 jack on the back or side of your TV and to
the HDMI OUT jack on the DVD or Blu-ray player.
To play from a DVD or Blu-ray player:
1 Turn on your TV, then press INPUT to open the
INPUT SOURCE list.
2 Press or to select HDMI 1 or HDMI 2, then press
ENTER.
3 Turn on the DVD or Blu-ray player, then set it to the
output mode. See the documentation that came
with the device for more information.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
COMPONENT IN
ANT/ CABLE IN
P
B
Y
AUDIO
LR
PR
Back of TV
Coaxial cable
Note
You can also press HDMI repeatedly to select HDMI1
or HDMI2.
PC IN
DIGITAL OUTPUT
VGA
AUDIO
HDMI 1
Back of TV
DVD or Blu-ray player
HDMI cable
DX-24L-32L-46L_11-0908_V2.book Page 12 Thursday, August 25, 2011 2:57 PM