Filter
Top Products
11
4. Connect the cables from the receiver’s back panel
S
ATELLITE IN port(s) to the TO RECEIVER SATELLITE IN
port of the power inserter installed in the previous step,
or to switch ports
d through f labeled TO RECEIVER
S
ATELLITE IN.
Note: If installing a DISH Pro Plus two-tuner receiver
using a single cable, install a DISH Pro Plus Separator as
follows:
a. Connect a cable from a T
O RECEIVER SATELLITE
I
N port on either the switch or power inserter to the
DISH Pro Plus Separator.
b. Connect cables between the receiver S
ATELLITE IN
1 and S
ATELLITE IN 2 to ports 1 and 2 respectively on
the DISH Pro Plus Separator.
4. Make sure all connections are secure.
5. Plug the power supply for the power inserter into a power
outlet.
Do not connect the receiver to the ports
labeled T
O ADDITIONAL SWITCH as this can
cause receivers in the system to experience
loss of video.