Filter
Top Products
English - 20 -
Initial settings
When the TV set is operated for the first time,
the IDTV turns on first.
Because this is the first time the TV is used, there
are no channels stored in the memory and the
following message appears on the screen:
Please ensure aerial is plugged in. Do you
want to start first time installation?
Yes
No
• To start installation process, select “Yes”,
to cancel select “No”.
• To select the “Yes” or “No” option, highlight
the item by using
or buttons and press
the OK button.
The IDTV will automatically tune to the UHF
transmission channels 21 to 68, searching
for digital terrestrial TV broadcasts and
displaying the names of channels found. This
process will take about five minutes. To cancel
searching, you can press the M button at any
time during the process.
MENU
BBC ONE
BBC TWO
BBC CHOICE
Searching UHF channels 30. Please wait. This will take a few minutes
Cancel search
AUTOMATIC SEARCH
Channels:
12 %
After Automatic Search is completed, the
following message asking for analogue channel
search appears on the screen:
Yes
Do you want to search for
analogue channels?
No
To search for analogue channels, select
“Yes”. TV switches to the analogue TV mode.
The menu below is displayed to search for
analogue channels:
Auto. Programming System
Country
U.K.
Check the antenna cable
Start : Ok
Exit : TV
Language
English
Txt. Region
West Europe
Set Language item by pressing
or
button.
Press
or
button to highlight Country item
and then use
or
to set. Press
or
button to highlight Txt. Region. Select a region
by using
or
button. When finished, press
OK button to continue. To cancel, press the
TV
DTV
button.
For more information on this process, see
“Install Menu” section.
NOTE: For proper functioning of digital teletext
in DTV mode, you should set country
as UK in analogue APS.
General operation
Pressing the
TV
DTV
button at any time
while watching television programmes will
switch the TV set between displaying the
digital terrestrial television broadcasting and
its normal analogue broadcasting.
Information Banner
• Whenever you change channel, using the P-
/ P+ button or the numeric buttons, the TV
displays the broadcast picture along with an
information banner at the bottom of the
screen. This will remain on the screen for
approximately three seconds.
• The information banner can also be
displayed at any time while watching TV by
pressing the
button on the remote
control: