Filter
Top Products
English - 31 -
Main Menu
Channel List
Installation
Configuration
Timers
Language
TV Setup
Common Interface
You are required to subscribe to a pay channel
company to view the pay channels of the digital
terrestrial broadcasting.
Obtain the Conditional Access Module (CAM)
and the viewing card by subscribing to a pay
channel company, then insert them in the TV
using the following procedure.
Please note that you must be able to receive
Channel 5 in order to use the CI Slot with a
CAM.
• Switch off the TV and unplug from the mains.
• Insert the CAM, then viewing card to the slot
that is located in the terminal cover at the
left-hand side of the TV (from front view).
• The CAM should be correctly inserted, it is
impossible to insert fully if reversed. The
CAM or the TV terminal may be damaged if
the CAM is forcefully inserted.
• Connect the TV to the mains supply, switch
on and then wait for few moments until the
card is activated.
• Some CAMs may require the following set
up. Please set the CAM by entering the IDTV
menu, Common Interface then pressing the
OK button. (CAM set up menu is not
displayed when it is not required.)
• To see the viewing contract information: enter
IDTV; press the M button, then highlight
Common Interface and press the OK button.
• When no module is inserted, “No Common
Interface module detected” message
appears on the screen.
• Refer to the module instruction manual for
details of the settings.
NOTE: Insert or remove the CI module only
when the TV is in STAND-BY mode or
SWITCHED OFF.
ENG-19796W-1050UK-17MB24H-IDTV-(BACK LINE OUT-YPbPr-WO SVHS)-LIPS-50118956.p65 25.04.2008, 10:0631