Filter
Top Products
45
Using the 3D Glasses with Power Supply
If you slide the switch to 3D or 2D after taking steps 1
and 2 in Recharging the 3D Glasses (see page 44),
you will be able to supply power to the 3D Glasses
while using the glasses (battery will not be recharged).
• Do not move around while wearing the 3D Glasses. Doing
so may result in getting your feet caught in the USB cable,
the TV falling or other accidents that may cause injury.
• When you supply power to the 3D Glasses, only connect
a USB cable (commercially available) to a USB terminal on
the TV.
• When you use the USB cable connecting the 3D Glasses,
be careful not to get your feet caught in the USB cable.
It may result in falling or other accidents that may cause
injury.
Removing the Battery for Recycling
The following instruction and procedure is provided
solely as a guide for the safe removal of the Li-ion
battery for proper disposal. This product is not
repairable. Do not attempt to replace the battery;
once the 3D Glasses are taken apart, they cannot
be reassembled or used again.
- Please take special care in handling small parts such as
screws specially around children that can accidentally
swallow them.
- Be very careful in handling the battery to prevent it from
leaking.
- Do not attempt to dismantle or puncture the battery.
- Do not use this battery for any other purpose. Recycle
properly after removing it from the 3D Glasses.
If you have any question regarding proper recycling
please call 1-800-822-8837 (see page 50 for more
details).
1
Pull out the nose pad with your fi ngers.
2
Remove the fi ve screws with a Phillips screwdriver
(commercially available).
Enjoying 3D Image Viewing
3
Pull the front casing outward with your fi ngers while
pulling the base of the right temple arm inward with
your fi ngers (
s
).
1
Front casing
2
Base
3
Right temple arm
4
Cut off the three cables of the rechargeable battery
unit one by one with a pair of scissors.
• There is the rechargeable battery unit inside
2
on the
right temple arm shown below.
• Insulate the tip of the removed rechargeable battery
cables, with material such as electrical tape, be sure
to insulate all three battery cable tips to prevent the
conductor wires from touching each other.
1
Right temple arm
2
Rechargeable battery unit
3
Rear casing
5
Pull out the entire rechargeable battery unit and
remove it from the rear casing.
• Used batteries should be handled in accordance with local
laws and regulations.