Filter
Top Products
+ , '!#!
'
))%
On the Camera Setup tab, you can specify the names of cameras, the sensor to be triggered for each camera, and the cameras
that are to record if motion is detected. If the camera is a Pan/Tilt/Zoom (PTZ), you can also specify the type of camera.
Figure 6. Camera Setup
-". '
To create or modify your camera settings, follow these steps:
1. Select Enable on the camera that you wish to be enabled.
This feature is NOT available on ELMO DVR Remote.
2. Enter a descriptive Name for each camera. The name has to have the following format: Camera ID-Name.
3. Enter the Sensor number(s) that will trigger the camera to record if it is set in Sensor Record mode and the sensor is activated.
4. Enter the camera number(s) that will record when motion occurs.
5. Select P/T/Z if the camera supports the PAN/TILT/ZOOM feature.
This feature is NOT available on ELMO DVR Remote.
6. Select the Type of camera if the camera supports the P/T/Z feature.
Related Topics: Sensor Setup | Control Setup | External Monitor | Motion Detection
' % .
10 - ELMO USER MANUAL 2003G