Filter
Top Products
76 Problem Solving
■ Make sure that your projector is connected to the correct WirelessHD device.
See“WirelessHD Settings” on page 47 for more information.
■ You may need to reset the WirelessHD connection. Turn off both the WirelessHD
Transmitter and the projector. Start playback on your video device, then turn on the
WirelessHD Transmitter and the projector. Wait 10 seconds, then press the
Setup
button on the back of the transmitter.
■ Make sure the WirelessHD Transmitter is not placed on a metal surface, as this may
interfere with the signal.
■ If the green and orange lights on the transmitter are flashing, the unit may be
overheating. Make sure the vents on the back of the transmitter are not blocked and that
the room temperature does not exceed 95 °F (35 °C).
WirelessHD images are displayed, but the picture quality is low.
The resolution and overall image quality are automatically adjusted based on the strength of
the WirelessHD signal. Check the WirelessHD reception (see page 47) and adjust the
position of the transmitter, if necessary.
pl3010_3010e_UG.book Page 76 Wednesday, September 7, 2011 6:28 PM