Filter
Top Products
Adjusting Colour for Several Projectors (Multi-Screen Colour Adjustment)
24
B
Choose the ID you want to set and press the [Enter]
button.
C
Press the [Menu] button to close the configuration
menu.
• Point the remote control at the remote receiver on the projector
you want to operate, press the numeric button corresponding to
the screen ID set while holding down the [Num] button, and then
you can operate only the projector specified with the ID number.
• You can operate all projectors regardless of the screen ID
settings by pointing the remote control at the remote receiver on
the projector, and pressing the [0] button while holding down the
[Num] button.
Image Correction Method
After setting up the projectors, adjust the brightness and tone for each
image.
A
Press the [Menu] button and select "Extended" -
"Multi-screen" - "Image Correction" from the
configuration menu. s p.31
B
Select the level to be adjusted in "Adjustment
Level".
• Each time a level is selected, the pattern of the level selected is
displayed.
• You can start adjusting from any level, usually you can make it
darker or lighter by adjusting 1 to 5 or 5 to 1.
C
Adjust the brightness with "Brightness Correct.".
• When you select level 5, it adjusts to the darkest image from
several projectors.
• When you select level 1, it adjusts to the brightest image from
several projectors.
• When you select level 2 to 4, it adjusts to the mid-range
brightness image from several projectors.
• Each time the [Enter] button is pressed the image displayed
changes between the pattern display and the actual image, and
you can check the adjustment results and make corrections in the
actual image.
q
• The screen IDs set here are only effective during "Image
Correction" for "Multi-screen".
• If a projector that is not the object of operation reacts to
the remote control, point the remote control at the remote
receiver on that projector and press the number set as that
projector's screen ID while holding down the [Num]
button.
Procedure