EverFocus EDR-1640 DVR User Manual


 
ATTENTION: The installation should be effected by qualified personnel only.
Connect power source only after having finished the further installation.
2.1 Delivery scope
2. INSTALLATION
Check the delivery scope (see 4.) before starting the installation.
2.2 Video connection installation, DVR cascading
15
Sample installation with maximum camera and monitor configuration:
Cameras and monitors have to be cabled with 75 Ohm video cable, e.g. RG-59, RG-12 and
suitable BNC plugs.
Due to inappropriate absorbability, 50 Ohm coax cable (e.g. RG58), antenna cable and
further types of coax cable are not suitable.
All connected video sources must provide a 1 Vpp PAL/CCIR standard video signal.
When interconnecting transmission lines (twisted pair, fibre optics, radio) to the video inputs,
ensure the accurate receiver calibration.
The MAIN monitor may optionally be connected through a Y-C (S-Video) cable to achieve an
improved image quality.
For local DVR operation, MAIN monitor connection is compulsory. Call and matrix monitors
can be connected optionally.
ATTENTION: Make sure that there‘s a video signal on video input 1 upon start-up, as this
input is required for video system auto detection (PAL/NTSC)!