EverFocus TP-S1016DR DVR User Manual


 
Operation
5. Operation
(1) Insert a HDD (IDE) for Video Storage
Insert one or two HDD (3.5” IDE) for Video Storage.
The HDD should be set as Cable Select.
(Normally the default setting of HDD is Master)
Note: After hard disk case is inserted into the hard disk tray, be sure to turn the tray key
in lock position.Otherwise, HDD will not be detected.
ATTENTION: Changing HDD s and switching on HDD s is not allowed in record mode!
(2) Connect cable for video/audio input and video/audio out,
The detail connection is described in SYSTEM CONNECTION.
(3) Switch Power On
The LCD panel in the front panel will light when you switch on the power.
(4) Press MENU key to enter SET UP MENU.
Once inside the main menu you will find there are 14 set up pages as below:
Selected item will be surrounded by a white block.
MENU
MAIN MENU
TIMER
SEQUENCE
TITLE
COVERT
ALARM
MOTION
RECORD
NETWORK
CONTROL
BUZZER
ARCHIVE
MATRIX
DISK
SYSTEM
CLOCK
(5) Turn the JOG dial clockwise or counter-clockwise to select the item,
press ENTER key for detail set up for each item.
(6) Press MENU again to leave the set up menu.
8