Filter
Top Products
10
2. Do not exit or power off during backup, or it will affect the backup of recording
file.
3. Please see the detailed operation manual in the CD.
2.5 Alarm setup
2.5.1 Alarm wiring diagram
The input side on the back panel of DVR shown as below, please refer to the physical
interface of the faceplate:
Note:
The above is the 1CH alarm in and 8CH alarm in figure. The back panel of 16CH is 4CH
alarm out and 16CH alarm in with the same priciple. The above is the normal on status
connection figure.
2.5.2 Motion Detection
Main Menu --> Alarm
Sensitivity refers to the motion detection sensitivity which can be set when the recording
mode is ALARM or SCHEDULE&ALARM. Choose the sensitivity from the drop-down
list, confirm and save the parameter.
Setting procedures:
1. Select channel, sensitivity and detection areas. Sensitivity is off by default with 1-9
options. Detection areas are all by default.
2. Save the parameters and set recording schedule by time. (Please see the 2.3.3
recording schedule for reference.)
(1) Select partial areas in the detection area column on (1) the motion detection
interface.
(2) On the motion detection interface(left picture), draw the areas to be detected. Red
Nomal open
Alarm input
Alarm
output
+ - G 12V G 1 2 3 4 5 6 7 8
Alarm
Alarm trigger
Power