Filter
Top Products
Command ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
Output Configuration (continued)
HDCP Status (DSC 3G-HD A only)
Query output
E O 1 HDCP ] X4$ ]
In verbose modes 2 and 3:
Hdcp O 1 * X4$ ]
View HDCP status X4$ of the
digital output.
Input lock (Accu-Frame Lock [AFL]) or SDI Genlock
Disable genlock or
Input AFL
E 0 GLOK } Glok 0 ]
Disable global input lock (AFL) or
genlock (default).
Enable input AFL
E 1 GLOK } Glok 1 ]
Lock the output refresh rate to
the rate of the selected input.
Enable SDI genlock
(DSC HD-3G A only)
E 2 GLOK } Glok 2 ]
Lock the output refresh rate to
the applied genlock signal.
View the genlock or AFL
setting
E GLOK } X6$ ]
In verbose modes 2 and 3:
Glok X6$ ]
View the current global input
lock (AFL) or genlock setting.
View genlock or AFL
status
E 41 STAT X6% ]
In verbose modes 2 and 3:
41 Stat • X6% ]
View the current global input
lock (AFL) or genlock status.
Genlock Offset (DSC HD-3G A only)
Set horizontal offset
E H x GLOF } Glof H x ]
Set the horizontal genlock offset
to x pixels. The x value (genlock
pixel offset) range is ± the
current output resolution total
pixel value -1.
Example: -2199 – +2199 for
1080p
View horizontal offset
E H GLOF } x ]
In verbose modes 2 and 3:
Glof H x ]
View the horizontal genlock
offset (default = 0).
Set vertical offset
E V y GLOF } Glof V y ]
Set the vertical genlock offset
to y pixels. The y value (genlock
pixel offset) range is ± the
current output resolution total
pixel value -1.
Example: -1124 – +1124 for
1080p
View vertical offset
E V GLOF } n ]
In verbose modes 2 and 3:
Glof V y ]
View the vertical genlock offset
(default = 0).
NOTES:
• Genlock offset commands return an error code unless SDI genlock is currently enabled and genlock is
currently locked to an applied genlock reference.
• Genlock offsets apply only to the current output resolution and reset to 0,0 when the output resolution is
adjusted.
NOTE: X4$ = HDCP status: 0 = no sink device detected, 2 = sink detected
X6$ = Input lock (AFL) status:
0 = Input lock disabled (default)
1 = Input lock is enabled but cannot lock to applied input signal (defaults to the set output rate).
2 = Input lock is enabled. The output is locked to the applied input signal (AFL).
X6% = SDI genlock status:
0 = Disable (default), 1 = Priority to highest numbered input, 2 = Priority to lowest numbered input
DSC 3G-HD A and DSC HD-3G A • Remote Configuration and Control 56