Filter
Top Products
- 54 -
CM1000A
Option Menu 1
Feature Factory Default Optional
1
Lock/Unlock Pulse Duration 0.8 sec 4 sec
2
Application of Pre-Wired Kill Relay Starter Kill Anti-Jacking (Ign Kill)
3
Door Open Parking Light Indicator Disabled Enabled
4
30 sec Passive Relock Disabled Enabled
5
Double Pulse Unlock Disabled Enabled
These option descriptions are for the CM1000A ONLY. They differ from the regular
option menus so much that they need their own section. The full listing of option menu
descriptions immediately follows this page.
1. Lock / Unlock Pulse Duration
This option determines the output duration of the lock and unlock pulses Some Vehicles
do not respond to short lock/unlock pulses.
2. Application of Pre-Wired Kill Relay
This option requires that the starter kill relay be installed in the ignition circuit, rather than
into the starter circuit. With this option turned on, Panic mode will become Anti-Jacking
mode. If Anti-Jacking is activated while the vehicle is running with the key in the ignition,
the siren will sound for 30 seconds. After 30 seconds the system will break the ignition
circuit, thereby disabling the vehicle. The siren will continue to play for 1 more minute.
With this option turned off, when Panic mode is activated, the system will arm, activate
the starter kill, and play the siren for 1.5 minutes.
3. Door Open Parking Light Indicator
With this option enabled, the parking lights will flash if a door is left open while the vehicle
is being armed. This serves as a warning that all of the doors have not been closed.
4. 30 sec Passive Relock
With this option enabled, after disarming the system with the remote, the system will
relock the doors and arm the alarm after 30 seconds if a door has not been opened. At
10 and 20 seconds after the disarm command was given, the siren will chirp once to
indicate that the alarm is about to rearm. At 30 seconds after, the siren will chirp once,
and the system will arm the alarm. If you wish to stop this process, you must open a door
within 30 seconds of disarming the alarm.
5. Double Pulse Unlock
With this option enabled, the unlock wire will perform a double pulse every time the
unlock command is given. Some vehicles require this double pulse to operate the locks
correctly.