Filter
Top Products
E-7
EnglishDeutschEspañolFrançaisItalianoPortuguês
日 本 語
Póññêèé
中文
/I power switch
If this button is pressed when the power indicator lamp is off, the indicator lamp will light.
The power can be turned on and the standby mode selected by using the remote control or the control panel of the display.
If this button is pressed when the power indicator lamp is lit, the indicator lamp will go out.
*Power is still supplied to parts of the display even if the indicator lamp is off.
RGB1 input terminal (RGB1 INPUTmD-sub)
Connect this terminal to the output terminal of a PC, set-top box, game, etc.
SCART input terminal (VIDEO1 INPUT)
SCART input terminal (VIDEO2 INPUT)
Connect this terminal to the SCART terminal of your VCR or DVD, etc. (See “SETTING THE INPUT TERMINALS” on P. E-25)
Component Video input terminal (VIDEO3 INPUT)
Connect this terminal to the Component Video Output terminal of DVD recorder/player or satellite receiver.
VIDEO4 input terminal (VIDEO4 INPUT/HDMI)
VIDEO5 input terminal (VIDEO5 INPUT/HDMI)
Connect this terminal to the HDMI output terminal of DVD recorder/player or other video source.
Audio4 input terminal (AUDIO4 INPUT)
Audio3 input terminal (AUDIO3 INPUT)
Connect this terminal to the audio output terminal of your VCR, etc. (See “Audio Input” on P. E-27)
Antenna input terminal
Please connect it to the antenna signal.
Power input terminal
Connect this terminal to the power cord supplied with the plasma display.
When connecting a cable, attach a ferrite core to the cable. (See P. E-4.)
•The table below shows the settings of Audio inputs. (Factory setting)
* For changing of Audio input settings, see “Audio Input” on P. E-27.
DISPLAY SECTION – BOTTOM
Video input
Audio Input
RGB1 (mD-sub)
Audio3
Video1 (Scart) Audio1 (Scart)
Video2 (Scart)
Audio2 (Scart)
Video3 (Component Video)
Audio4
Video4 (HDMI)
Audio5 (HDMI)
Video5 (HDMI)
Audio6 (HDMI)
01_E_7473.book 7 ページ ２００６年９月６日 水曜日 午後２時３６分
Downloaded From TV-Manual.com Manuals